Vocal Dynamic Microphone
MD-305

MD-305 is noticeably "stronger" than the condenser MK-207. It is less sensitive to environmental factors and allows a certain carelessness in handling.
The MK-207 microphone brings the quality of live performances to the studio level, but at the same time, despite the robust body and grill, it requires more careful handling.
The frequency response of the dynamic microphone is optimized for vocals, which allows you to use it "out of the box", without equalization.
The MK-207 has a more uniform frequency response, which makes its scope of application more extensive, but sound check and additional equalization will be required for full operation.

Yes. Despite the optimization of the frequency response for vocals, the MD-305 dynamic microphone shows itself perfectly when recording and sounding strings, wind instruments and some percussion.
The listed areas of application are of the nature of recommendations and should not limit your creative search.

Audio interface or mixing console with XLR-3 connector. The presence of 48 V phantom power is not required.

The warranty period for the microphone is two years.
In the event of a breakdown, your microphone will be put in order on the factory equipment by specialists who participated in its assembly.
Please keep the warranty card for the entire life of the microphone.

The average service life of the microphone is at least ten years.
Probably, after this period, your microphone will need to replace the foam inserts.

Oktava microphones are created in the center of the artisan capital of Russia - in Tula.
The full production cycle from development to assembly takes place at the Oktava plant.

Yes. Write to us in the chat specifying the contact email, address and name of the studio.

Point the speakers away from the microphone.
The microphone should be kept at a uniformly close distance to the sound source,
in this case the sound engineer will not have to increase the gain to maintain the signal level.

1. Connect the microphone to the mixing console or audio interface with an XLR-3 microphone cable
2. Make sure that the phantom power on the mixing console is turned off.